They can easily become mis aligned due to bumping twisting and loose mounting.
Have to hold wall button to close garage door.
If remote controls do not work then replace the wire.
So if you have to do this to close the door it means the sensor is malfunctioning.
A wall console unit for a garage door opener is not a complicated device so it s fairly simple to troubleshoot when something seems to go wrong.
The solutions first check your fuses gfci or breaker to see if any of them have tripped broken or burnt out.
Any transmitter like a handheld clicker.
You will find that the door will only move an inch or so in the close direction and reverse.
Why do i have to hold down the button to close the garage door.
To get it to close i have to hold the button in until it gets to the bottom.
If i push the button to close it the light flashes and it comes back up.
Step by step procedures to try if the garage door of your home will not go down without holding the button before calling a repair man was this video helpful.
My name is xxxxx xxxxx would be glad to assist.
Remove the wires from the back of the door control.
Depending on the model most work by connecting two to four wires onto terminals mounting the device on the wall and then plugging the unit into an electrical outlet.
The transmitters remotes will not work to close the garage door.
When this happens your garage door will only close by holding down on the wall button or wall console until the door fully closes.
Is this something i can fix without calling a garage door guy.
The garage door opens fine.
If you have a problem with your wall switch being unable to open or close the garage door then it s often a problem somewhere in the power supply.
You are overriding the infrared beam sensor when you hold down the wall button continuously while the garage door is closing.
Go to the door control take the door control off the wall by popping off the push button.
There is a screw under the push button that holds the door control on the wall.